Schematic Problem with large sheets

I noticed that there was only one schematic frame and it was for A4 size Landscape. I went ahead and created the remaining frames for A0-A4 both landscape and portrait.

I ran into a problem with the A0 and A1 frames. If you create a rectangle of those sizes with the lower left
corner anchored at the origin then you can’t edit the lower right corner. You can zoom out and see the entire rectangle but if you zoom into the lower right corner it gets forced off screen because of where the origin is anchored.

I am using 0.1.2

For the record, the PR with the schematic frames is here.